alliance RV paradigm 2021 Basic Operation of Stereo User Manual

Table of Contents

alliance RV paradigm 2021 Basic Operation of your Stereo User Manual

Basic Operation of your Stereo

Audio Menu Settings
- Press the settings button (14) to access the audio menu.
- Press the << or >> buttons (6, 8), or settings button repeatedly to navigate through the audio menu selections.
- Once the desired menu item (bass; treble; balance; fade; loudness; equalization) appears on the display, adjust the option by rotating the vol/enter knob (4) either direction within 5 seconds.
- Press the back button (2) to confirm your selection and exit the audio menu. NOTE: The stereo will exit the audio menu after 5 seconds of inactivity.
System Menu Settings
- Press and hold the settings button (14) for 2 seconds to access the system menu.
- Press the << or >> buttons (6, 8) or settings button repeatedly to navigate through the system menu items.
- Once the desired menu item (Bluetooth device; beep; region; Bluetooth; preset volume; reset) appears on the display, adjust the option by rotating the vol/enter knob (4) either direction within 5 seconds.
- Press the back button (2) to confirm your selection and exit the audio menu. The unit will automatically exit the menu after 5 seconds of inactivity.
Auxiliary Input
- When an exterior audio device is connected to the unit, press the mode button
  (15) repeatedly until you see front/rear aux mode. To connect device, insert a standard 3.5mm audio cord into the input (11) on the front of the unit (there are auxiliary in RCA jacks on the rear of the unit)
USB Interface
- You can connect a USB device directly to the USB input (10) on the front of the stereo for the playback of compatible files. (refer to “Auxiliary Input) covered above to select this mode. NOTE: Will not support Apple device playback.
Dimming control
- Press the dim button (17) on the front panel to turn the dimmer on, press again to turn the dimmer off.
- Press and hold the dim button to access the dimmer level menu.
- Rotate the volume knob to increase or decrease the dimmer level.
- Press back (2) to confirm your selection.
Time Menu Settings
- Press the time button (18) to access the time menu settings.
- Press the << or >> buttons or time button repeatedly to navigate the time menu.
- Once the desired time menu item appears (sleep timer; alarm on/off; alarm set; clock set) on the display, adjust the selection by rotating the volume/enter knob.

See your stereo manual for full details on this stereo.

alliance RV paradigm 2021 Top Accessories

[amalinkspro_table id=”32452″ new-window=”on” nofollow=”on” addtocart=”off” /]

MONITOR PANEL

This system allows monitoring of fresh water, gray water, black water and battery levels. All functions are controlled from computer grade tact switches for easy operation. Power control of the water heater, water pump, tank heaters, some of the RVs lights, awnings and slideouts are also done from the central monitor panel shown below.

AWNINGS

Your Alliance RV comes standard with a power awning and in some cases, depending on the floor plan, may have two power awnings installed from the factory.

Awning Operation

Extending the Awning

First, verify that the battery is fully charge and connected to the electrical system.
Press and hold the awning extend button in the monitor panel.

NOTE: Extension is considered complete when the fabric is completely unrolled, the valance sean is visible and a section of the awning tube is exposed.
NOTE: The fabric should always be above the tube. However, if the extend switch is engaged too long or it is accidentally hit, the awning will roll up backward. To correct the orientation of the fabric, press the retract button to extend it to its correct position and normal operation can resume.
NOTE: Tying down the roller tube once the awing is extended will not all the free floating support arms to work as designed and can cause damage to the awning or RV

Retracting the Awning

Always check the battery first to ensure it’s charged and tied into the electrical system.
- NOTE: The awning can be retracted without resetting the pitch.
Press and hold the retract button until the awning is retracted completely.

Adjusting the Awning Pitch

The pitch can be set by adjusting the articulating arm to tip one side of the awning in order to allow water runoff.
NOTE: The awning will pitch by itself to purge discard the pooling of excess water.
Extend the awning.
Choose the side of the awning for optimum shade or convenient water runoff. Pull down on the joint of the articulating arm until desired pitch is set to allow for water runoff.
Never push the joints of the articulating arms up. This will put tension on the gas strut, which can cause the strut to break.
NOTE: If the articulating arm does not hold position, it can be tightened by adjusting the bolt in the center of the articulating arm.

CAUTION
During incidents of high wind, heavy rain or extended time away from the RV, be sure to retract the awning completely to prevent damage to the warning and the RV.

Reference Links

View Full User Guide: alliance RV paradigm 2021 User Manual

Download Manuals: https://dev.alliancerv.com/owners-manuals