2022 Audi R8 Fuses and Fuse Box User Guide
In order to guarantee that your car’s electrical systems run well, we will go over the locations, purposes, and replacement advice of the 2022 Audi R8’s fuses and fuse box in this article.
2023 Audi R8 Coupe Specs, Price, Features, Mileage and Review
Video: 2022 Audi R8 Fuses
Replacing fuses
Fuses are installed in various locations in your vehicle. The following information only lists fuses that you can change yourself. To have other fuses changed, contact an authorized Audi dealer or authorized Audi Service Facility. The following table does not list fuse locations that are not used. A fuse that has blown will have metal strips that have burned through. The fuses are located in the front passenger’s side footwell behind a cover.
Fuses in the interior
- Switch the ignition and all electrical equipment off.
- Check the table that follows to see which fuse belongs to the affected equipment.
- Fold the floor mat back.
- Remove the cover f© ig. 185.
- Remove the plastic clip from the fuse panel.
- Remove the colored plastic bracket from the fuse panel, if present.
- Remove the fuse using the clip.
- Replace the blown fuse only with a fuse that has the same amp rating.
- Reinstall the plastic bracket, if present.
- Install the cover.
Fuse color identification
| Color | Current Rating in amps |
| Black | 1 |
| Gray | 2 |
| Purple | 3 |
| Pink | 4 |
| Light brown | 5 |
| Brown | 7.5 |
| Red (narrow) | 10 |
| Light blue | 15 |
| Yellow | 20 |
| White or transparent | 25 |
| Light green | 30 |
| Teal | 35 |
| Orange | 40 |
| Red (wide) | 50 |
Warning
Do not repair fuses and never replace a blown fuse with one that has a higher amp rating. This can cause damage to the electrical system and increases the risk of fire.
Note
If a new fuse burns out again shortly after you have installed it, have the electrical system checked as soon as possible by an authorized Audi dealer or authorized Audi Service Facility.
Tips
Some of the equipment listed in the following tables applies only to certain model versions or certain optional equipment.
Fuse Assignment
| No | Equipment |
| 1 | Steering column electronics |
| 2 | Roof electronics control module, all wheel drive control module, front passenger’s airbag indicator light, switch panel, power steering |
| 3 | Anti-Lock Braking System (ABS), Electronic Stabilization Control (ESC), sensor electronics control module |
| 4 | Dynamic steering |
| 5 | Garage door opener |
| 6 | Diagnostic connection, headlight range control, vehicle electrical system control module |
| 7 | Diagnostic interface |
| 8 | Anti-lock braking system (ABS), Electronic Hom Stabilization Control (ESC) |
| 9 | Airbag control module, front passenger’s seat electronics |
| 10 | Humidity sensor, A/C system pressure temperature sensor |
| 11 | Left headlight |
| 12 | Engine sound control module |
| 13 | Right headlight |
| 14 | Rearview mirror |
| 15 | Engine start |
| 16 | Drivetrain control module, automatic transmission |
| Fuse panel (Black) | ||
| 3 | Climate control system blower | – |
| 4 | Vehicle electrical system control module | – |
| 5 | Emergencacll ya nd communication control module |
– |
| 6 | [Rearview camera | – |
| Fuse panel (Black) | ||
| 1 | Diagnostic connection | – |
| 2 | Parking brake | – |
| 3 | Diagnostic interface | – |
| 4 | Brake booster | – |
| 5 | 12 volt socket | – |
| 6 | Instrument cluster | – |
| 7 | Immobilizer control module | – |
| 8 | Ignition interlock control module | – |
| 9 | Emergenccyal l module | – |
| – | – | – |
| – | – | – |
| Fuse panel (red) | |
| No | Equipment |
| 1 | Anti-lock braking system (ABS) |
| 2 | Ignition power circuit power supply |
| 3 | Refrigerator |
| 4 | Electric drive system, power electronics |
| 5 | Brake system |
| 6 | High-voltage battery water pump |
| 7 | Auxiliary climate control |
| 8 | Climate control system compressor |
| 9 | Auxiliary battery control module |
| 10 | High-voltage battery |
| 11 | High-voltage charger |
| 12 | Steering column electronics |
| 13 | Light switch |
| Fuse panel (Brown) | ||
| 1 | Seat ventilation, seat electronics, rearview mirror, rear climate control system control panel, diagnostic connection, traffic information antenna (TMC) | – |
| 2 | Vehicle electrical system control module, diagnostic interface | – |
| 3 | Engine sound control module | – |
| 4 | Transmission fluid cooling valve | – |
| 5 | Engine start, electric drive | – |
| 6 | Active acceleratpoedral | – |
| 7 | Night vision assist, active roll stabilization | – |
| 8 | Adaptive cruise assist, front wheel sensors | – |
| 9 | Inteasrsisstante, cdritver iasosistn systerm | – |
| 10 | Right headlight | – |
| 11 | Left headlight | – |
| 12 | Sound system, ignition power circuit power supply |
– |
| 13 | USB connection | – |
Bulbs
Note
Your vehicle is equipped with maintenance-free headlights and tail lights. However, if a light bulb needs to be replaced, please contact an authorized Audi dealer or authorized Audi Service Facility.
2023 Audi R8 Coupe Specs, Price, Features, Mileage and Review
How to Replace the Fuse of the 2022 Audi R8
Replacing the fuses in your 2022 Audi R8 is a straightforward process, but it’s important to follow the proper steps to ensure safety and that you replace the correct fuse. Here’s how you can do it:
Materials:
- The new fuse of the correct amperage.
- Fuse puller or needle-nose pliers.
Steps to Replace Fuses:
- Turn Off the Vehicle
- Ensure the vehicle’s ignition and all electrical components are turned off to prevent electrical shocks or further damage.
- Locate the Fuse Boxes
- The 2022 Audi R8 typically has multiple fuse boxes:
- Engine Compartment: Near the battery or under a protective cover.
- Driver’s Side: Behind a panel near the dashboard or under the driver’s side footwell.
- Passenger’s Side: Sometimes behind a glove compartment or under the footwell.
- The 2022 Audi R8 typically has multiple fuse boxes:
- Consult the Fuse Diagram
- Check the fuse box cover for the diagram. This will indicate the location and purpose of each fuse.
- Identify the Faulty Fuse
- Look for a blown fuse. A blown fuse typically has a broken metal strip or shows signs of discoloration.
- Remove the Blown Fuse
- Use a fuse puller or pliers to gently remove the faulty fuse. Avoid damaging the fuse socket.
- Inspect and Replace
- Match the amperage of the replacement fuse with the blown fuse. (For example, a 15A fuse should be replaced with a 15A fuse.)
- Insert the new fuse into the socket until it is secure.
- Test the Circuit
- Turn the vehicle on and test the circuit to ensure the issue is resolved.
- Close the Fuse Box
- Secure the fuse box cover and ensure all panels are properly reattached.
- Tips:
- Always use a fuse with the correct amperage rating to prevent electrical issues or damage to the vehicle.
Useful Links:
View Full PDF: 2022 Audi R8 Owner’s Manual | Auto User Guide
2022 Audi R8 Warning Lights and Indicator User Guide
2022 Audi R8 Engine Oil and Fluid User Guide