How To Instal STKR Concepts 00-382 Garage Parking Sensor User Manual
The STKR Concepts 00-382, introduced in 2020, improves garage parking accuracy and safety. An easy-to-install device with adjustable ultrasonic sensors measures distances accurately. Visual guidance from its powerful LED indicators prevents vehicle harm.
Power via 4 AA batteries OR optional USB port:
- The USB port is NOT a charging port. It is a power port only.
- USB charger and wire NOT included. The USB Power port is an optional way to power your parking sensor. Use your own mini USB “cell phone” style USB power cable and plug as an alternate power source to alkaline batteries.
Installing Batteries
This unit requires 4 AA batteries.
- Remove the battery compartment cover on the back of the sensor module.
- Insert 4 new ‘AA alkaline batteries (not included) according to
the polarity diagram compartment. inside battery - Replace cover.
When it is time to replace the batteries, the display module will flash a yellow light every 6 seconds.
MOUNTING THE GARAGE PARKING SENSOR ADHESIVE STRIPS & VELCRO MOUNTING:
The large display unit will be mounted within the drivers line of sight. The small sensor will be mounted directly below the display. It should be level with the center of the car bumper.
- Place the double-sided tape onto the back of the small
sensor module. - Mount the small sensor at bumper height of the vehicle that is intended for use with the Garage Parking Sensor. Be sure the area of the wall, or mounting surface, is clean and free of any dust and debris. (See associated Images marked with an “A”)
- Peel off one side of the protective backing on the adhesive Velcro, and stick it to the back of the display unit.
- Peel off the other side of the protective backing on the Velcro and mount it to the wall, or mounting surface, in front of the car at eye level for the driver. Be sure the surface you are mounting the display to is clean and free of any dust or debris. (See associated Images marked with an “B”)
OPERATION
The STKR® Garage Parking Sensor should now be properly installed and ready for use.
SETTING THE DESIRED STOPPING DISTANCE
The STKR® Garage Parking Sensor can be adjusted to set the stop zone from 6 inches away from the sensor up to 6 feet away from the sensor.
The default distance is set to turn the red light on at 1 foot from the sensor. If you would like a different stopping distance follow the steps below. You may change the distance as many times as you like.
- Park your car exactly where you want it (Ignoring the default settings on the parking sensor). It may be wise to have a 2nd person guide you to the desired location to ensure you don’t hit anything with your car.
- Once your car is parked exactly where you would like the red light to turn on, simply press the “Set Distance” button firmly. The red, yellow, and green LEDs will illuminate. Release the button (Note: you can reset the parking distance anytime by repeating this step).
- Kouminate the red light AI that decor every time your vehicle approaches the sensor.
- Test your new setting by slowly driving your car into your garage. If your reaction times are slow to stop the car when the red light illuminates, you may want to change the location when the red light illuminates to allow for the delay.
NOTE:
Garage Parking Sensor stop distances can vary due to vehicle type, temperature, and weather. It is important to check your reaction time and leave sufficient stopping distance for these variations. Always test the desired stop distance when parking a new vehicle and adjust the mounting location or stopping distance if necessary.
FAQs About STKR Concepts 00-382
It aims to prevent damage to vehicles and garage walls by indicating the optimal stopping point.
The price of usually STKR Concepts 00-382 ranges from $34.99.
It is used by positioning your car in the garage until the sensor’s light indicates you’ve reached the optimal stopping point.
It has a bright LED indicator that is visible even in low-light conditions.