2023 Chevrolet Blazer Interior Controls Owners Manual
We’ll delve into the specifics of the interior controls of the 2023 Chevrolet Blazer that are designed to make driving more comfortable and convenient. They enable drivers to modify a range of features, including music settings, climate control, and navigation.
Controls
Steering Wheel Adjustment
To adjust the steering wheel:
- Pull the lever down.
- Move the steering wheel up or down.
- Pull or push the steering wheel closer or away from you.
- Pull the lever up to lock the steering wheel in place.
Do not adjust the steering wheel while driving.
Interior Controls Guide
Power Tilt and Telescoping Steering Wheel
If equipped, the control is on the left side of the steering column.
Push the control up or down to tilt the steering wheel up or down.
- Push the control forward or rearward to move the steering wheel toward the front or rear of the vehicle.
- Do not adjust the steering wheel while driving.
Steering Wheel Controls
Heated Steering Wheel
If equipped, press to turn the heated steering wheel on or off. A light next to the button displays when the feature is turned on. The steering wheel takes about three minutes to start heating. If equipped with a remote start heated steering wheel, the heated steering wheel may turn on automatically in remote start along with the heated seats when it is cold outside. The heated steering wheel indicator light may not come on. See Heated and Ventilated Front Seats 0 41. To turn this feature on or off, select
Settings > Vehicle > Comfort and Convenience > Heated Steering Wheel >
Select ON or OFF.
2023 Chevrolet Blazer Interior Controls Owners Manual
Horn
Pres on the steering wheel pad to sound the horn.
Windshield Wiper/Washer
With the ignition on or in ACC/ACCESSORY, move the windshield wiper lever to select the wiper speed.
HI: Use for fast wipes.
LO : Use for slow wipes.
Chevrolet Blazer Windshield Wipers
- INT: Move the windshield wiper lever to
- INT. Turn the band up for more frequent wipes or down for less frequent wipes.
- OFF: Use to turn the wipers off.
- 1X: For a single wipe, briefly move the wiper lever down. For several wipes, hold the wiper lever down.
Pull the windshield wiper lever toward you to spray windshield washer fluid and activate the windshield wipers. The wipers will continue until the lever is released or the maximum wash time is reached. When the windshield wiper lever is released, additional wipes may occur depending on how long the windshield washer has been activated. See Washer Fluid 0 262 for information on filling the windshield washer fluid reservoir. Clear snow and ice from the wiper blades and windshield before using them. If frozen to the windshield, carefully loosen or thaw them. Damaged blades should be replaced. See Wiper Blade Replacement 0 265. Heavy snow or ice can overload the wiper motor. See Electrical System Overload 0 268.
2023 Chevrolet Blazer Interior Controls User Manual
Warning
- In freezing weather, do not use the washer until the windshield is warmed. Otherwise the washer fluid can form ice on the windshield, blocking your vision.
- Before driving the vehicle, always clear snow and ice from the hood, windshield, washer nozzles, roof, and rear of the vehicle, including all lamps and windows. Reduced visibility from snow and ice buildup could lead to a crash.
Wiper Parking
If the ignition is turned off while the wipers are on LO, HI, or INT, they will immediately stop.
If the windshield wiper lever is then moved to OFF before the driver door is opened or within 10 minutes, the wipers will restart and move to the base of the windshield. If the ignition is turned off while the wipers are performing wipes due to windshield washing, the wipers continue to run until they reach the base of the windshield.
Wiper Blade Adjustment
Rear Window Wiper/Washer
The rear window wiper/washer controls are on the end of the windshield wiper lever. Turn the controls to adjust the setting.
- OFF: Turns the wiper off.
- INT : Turns on the rear wiper with a delay between wipes.
- ON: Turns on the rear wiper.
- Push the windshield wiper lever forward to spray washer fluid on the rear window. The wipers will clear the rear window and either stop or return to your preset speed. For more washer cycles, press and hold the lever.
- The rear window wiper/washer will not operate if the liftgate is open or ajar.
- If the liftgate is opened while the rear wiper is on, the wiper returns to the parked position and stops.
Rear Wiper Arm Assembly Protection
When using an automatic car wash, move the rear wiper control to OFF to disable the rear wiper. In some vehicles, if the transmission is in N (Neutral) and the vehicle speed is very slow, the rear wiper will automatically park. The wiper operations return to normal when the transmission is no longer in N (Neutral) or the vehicle speed has increased.
Reverse Gear Wipes
If the rear wiper control is off, the rear wiper will automatically operate continuously when the vehicle is in R (Reverse) and the front windshield wiper is performing low or high-speed wipes. If the rear wiper control is off, the vehicle is in R (Reverse), and the front windshield wiper is performing interval wipes, then the rear wiper automatically performs interval wipes This feature can be turned on or off. Go to Settings > Vehicle > Comfort and Convenience > Reverse Gear Wipes > Select ON or OFF. The windshield washer reservoir is used for the windshield and the rear window. Check the fluid level in the reservoir if either washer is not working.
Rear Camera Washer
If equipped, push the windshield wiper lever forward to spray washer fluid on the rear camera lens. The lever returns to its starting position when released.
Compass
The vehicle may have a compass display on the Driver Information Center (DIC). The compass receives its heading and other information from the Global Positioning. System (GPS) antenna, StabiliTrak/Electronic Stability Control (ESC), and vehicle speed information. The compass system is designed to operate for a certain number of miles or degrees of turn before needing a signal from the GPS satellites. When the compass display shows CAL, drive the vehicle for a short distance in an open area where it can receive a GPS signal. The compass system will automatically determine when a GPS signal is restored and provide a heading again.
Blazer Compass Settings
Clock
Set the time and date using the infotainment system.
Power Outlets
Power Outlets 12-Volt Direct Current The vehicle is equipped with 12-volt outlets that can be used to plug in electrical equipment, such as a cell phone or MP3 player.
The power outlets are located:
- Inside the center console storage compartment.
- In the rear cargo area. Lift the cover to access the outlet and replace it when not in use.
- There are also charging-only USB ports on the rear of the centre console.
Warning
Power is always supplied to the rear cargo power outlet. Do not leave electrical equipment plugged in when the vehicle is not in use because the vehicle could catch fire and cause injury or death.
Caution
Leaving electrical equipment plugged in for an extended period while the ignition is off will drain the battery. Always unplug electrical equipment when not in use and do not plug in equipment that exceeds the maximum 15 amp rating.
Certain accessory plugs may not be compatible with the accessory power outlet and could overload vehicle and adapter fuses. If a problem is experienced, see your dealer. When adding electrical equipment, be sure to follow the proper installation instructions included with the equipment.
Hanging heavy equipment from the power outlet can cause damage not covered by the vehicle warranty. The power outlets are designed for accessory power plugs only, such as cell phone charge cords.
2023 Chevrolet Blazer Interior Controls User Guide
Power Outlet 110-V/120-V Alternating Current
If equipped, this power outlet can be used to plug in electrical equipment that uses a maximum limit of 150 watts.
The power outlet is on the rear of the center console. An indicator light on the outlet turns on to show it is in use. The light comes on when the ignition is on, equipment requiring less than 150 watts is plugged into the outlet, and no system fault is detected. The indicator light does not come on when the ignition is off or if the equipment is not fully seated in the outlet. If equipment is connected using more than 150 watts or a system fault is detected, a protection circuit shuts off the power supply and the indicator light turns off. To reset the circuit, unplug the item and plug it back in or turn the Retained Accessory Power (RAP) off and then back on. See Retained Accessory Power (RAP) 0 196. The power restarts when equipment using 150 watts or less is plugged into the outlet and a system fault is not detected. The power outlet is not designed for the following and may not work properly if they are plugged in:
- Equipment with high initial peak wattage, such as compressor-driven refrigerators and electric power tools.
- Other equipment requiring an extremely stable power supply, such as microcomputer-controlled electric blankets and touch-sensor lamps
- Medical equipment.
FAQ’s
The windshield wiper operation is controlled through the intuitive wiper controls on the steering column.
Automatic rain-sensing wipers detect precipitation and adjust wiping speed accordingly.
The heated wiper park area prevents the accumulation of ice and snow, enhancing wiper functionality in cold weather.
Useful Links
View Full User Guide: Chevrolet Blazer 2023 User Guide2023