Chevrolet Blazer 2023 User Interior Lighting Guide
Instrument Panel Illumination Control
This feature adjusts the brightness of all illuminated controls. The instrument panel illumination control is next to the exterior lamp control. Push the knob in all the way until it extends out and then turn the knob clockwise or counterclockwise to brighten or dim the lights. Push the knob back in when finished. The knob is functional at night, or when the headlamps or parking lamps are ON.
The courtesy lamps come on when any door is opened, on the remote key is pressed, or when the vehicle is turned off. See Dome Lamps 0 122.
The dome lamp controls are in the overhead console.
To operate, press the following buttons:
Press to turn off the dome lamps when any door is opened, K on the remote key is pressed, or when the vehicle is turned off. An indicator light on the button will turn on when the dome lamp override is activated. Press OFF again to deactivate this feature and the indicator light will turn off. The dome lamps will come on when any door is opened, K on the remote key is pressed, or when the vehicle is turned off. ON/OFF : Press to turn the dome lamps on or off manually.
ON/OFF : Press to turn the dome lamps on or off manually.
There are reading lamps on the overhead console and over the rear seats. These lamps come on when any door is opened.
Front Reading Lamps
The front reading lamps are in the overhead console. Press the lamp lenses to turn the front reading lamps on or off.
Rear Reading Lamps with Sunroof
Rear Reading Lamps without Sunroof
The rear reading lamps are over the rear seats. Press the lamp lens to turn the rear passenger reading lamps on or off.
The interior lamps turn on when pressing on the remote key or opening any doors, and the dome lamp control is in the door position. Some exterior lamps also turn on when pressing K on the remote key or opening any doors. Low-Beam lamps will only turn on briefly at night, or in areas with limited lighting. All lamps will gradually fade out after about 30 seconds. Entry lighting can be disabled manually by closing all doors, pressing on the remote key, or starting the vehicle. This feature can be changed. On the infotainment home page, select the Settings icon Vehicle Vehicle Locator Lights.
Some exterior lamps and interior lamps turn on when the driver door is opened after the vehicle is turned off. The exterior and interior lamps remain on for a set amount of time, then automatically turn off. The interior lights turn on when the vehicle is turned off. The exterior lamps turn off immediately by turning the exterior lamp control off. This feature can be changed. On the infotainment home screen, select the Settings icon T Vehicle T Exit Lighting.
Battery Load Management
The vehicle has Electric Power Management (EPM) that estimates the battery’s temperature and state of charge. It then
adjusts the voltage for best performance and extended life of the battery. When the battery’s state of charge is low, the voltage is raised slightly to quickly bring the charge back up. When the state of charge is high, the voltage is lowered slightly to prevent overcharging. If the vehicle has a voltmeter gauge or a voltage display on the Driver Information Center (DIC), you may see the voltage move up or down. This is normal. If there is a problem, an alert will be displayed.
The battery can be discharged at idle if the electrical loads are very high. This is true for all vehicles. This is because the generator (alternator) may not be spinning fast enough at idle to produce all of the power needed for very high electrical loads. A high electrical load occurs when several of the following are on, such as: headlamps, high beams, rear window defogger, climate control fan at high speed, heated seats, engine cooling fans, trailer loads, and loads plugged into accessory power outlets. EPM works to prevent excessive discharge of the battery. It does this by balancing the generator’s output and the vehicle’s electrical needs. It can increase engine idle speed to generate more power whenever needed. It can temporarily reduce the power demands of some accessories. Normally, these actions occur in steps or levels, without being noticeable. In rare cases at the highest levels of corrective action, this action may be noticeable to the driver. If so, a DIC battery voltage and charging message displays. It is recommended that the driver reduce the electrical loads as much as possible. See Driver Information Center (DIC) (Up level) 0 112 or Driver Information Center (DIC) (Base Level) 0 109.
Battery Power Protection
This feature helps prevent the battery from being drained if the interior courtesy lamps or reading lamps are accidentally left on. If any of these lamps are left on, they automatically turn off after 10 minutes, if the ignition is off. The lamps will not come back on again until one of the following occurs:
- The ignition is turned on.
- The doors are closed and then re-opened.
Exterior Lighting Battery Saver
The exterior lamps turn off about 10 minutes after the vehicle is turned off, if the parking lamps or headlamps have been manually left on. This protects against draining the battery. To restart the 10-minute timer, turn the exterior lamp control to the O position and then back to the or 2 position. To keep the lamps on for more than 10 minutes, the vehicle must be on or in accessory mode.
Chevrolet Blazer 2023 Top Accessories
[amalinkspro_table id=”32452″ new-window=”on” nofollow=”on” addtocart=”off” /]
View Full User Guide: Chevrolet Blazer 2023 User Guide
Download Manuals: https://www.chevrolet.com/support/vehicle/manuals-guides