Suzuki New CARRY 2019 Drive Belt User Manual

Suzuki Logo

Suzuki New CARRY 2019 Drive Belt User Manual

Drive Belt

WARNING
When the engine is running, keep hands, hair, clothing, tools, etc. away from the moving fan and drive belts.

Check that the drive belt tension is correct while the engine is stopped. If the belt is too loose, insufficient battery charging, engine overheating, poor air conditioning, or excessive belt wear can result. When you push the belt with your thumb midpoint between the pulleys, there should be a deflection according to the following chart. The belts should also be examined to ensure that they are not damaged. If you need to replace or adjust the belt, have it done by a SUZUKI dealer or a qualified workshop?Suzuki New CARRY 2019 Drive Belt User Manual 01

  1. Water pump
  2. Generator
  3. Tensioner pulley
  4. Air conditioner compressor (if equipped)

Drive belt deflection (100 N (10 kg, 22 lbs) press)

  • New:
    4.8 – 5.9 mm (0.19 – 0.23 in.)
    Readjustment:

    7.2 – 8.2 mm (0.28 – 0.32 in.)
  • New:
    4.0 – 5.0 mm (0.16 – 0.20 in.)
    Readjustment:

    6.1 – 7.1 mm (0.24 – 0.28 in.)

Engine Oil and Filter

Specified OilSuzuki New CARRY 2019 Drive Belt User Manual 02

Preferred
Check that the engine oil you use comes under the quality classification of SG, SH, SJ, SL, SM or SN. Select the appropriate oil viscosity according to the above chart.
SAE 5W-30 (1) is the best choice for good fuel economy and good stability in cold weather.

NOTE:
We recommend that you use SUZUKI genuine oil. To purchase it, visit a SUZUKI dealer or a qualified workshop.

Oil Level CheckSuzuki New CARRY 2019 Drive Belt User Manual 03Suzuki New CARRY 2019 Drive Belt User Manual 04

It is important to keep the engine oil at the correct level for proper lubrication of your vehicle’s engine. Check the oil level with the vehicle on a level surface. The oil level indication may be inaccurate if the vehicle is on a slope. The oil level should be checked either before starting the engine or at least 5 minutes after stopping the engine.
The handle of the engine oil dipstick (1) is colored with yellow for easy identification.

Left-hand drive vehicle:
Open the engine compartment (passenger’s side).

Right-hand drive vehicle:
Open the engine compartment (driver’s side).
Pull out the oil dipstick, wipe the oil off with a clean cloth, insert the dipstick all the way into the engine, and then remove it again. The oil on the stick should be between the upper and lower limits shown on the stick. If the oil level indication is near the lower limit, add enough oil to raise the level to the upper limit.

NOTICE
Failure to check the oil level regularly could lead to serious engine trouble due to insufficient oil.

RefillingSuzuki New CARRY 2019 Drive Belt User Manual 05

Left-hand drive vehicle:
Open the engine compartment (driver’s side).

Right-hand drive vehicle:
Open the engine compartment (passenger’s side).
Remove the oil filler cap (1) and pour oil slowly through the filler hole to bring the oil level to the upper limit on the dipstick. Be careful not to overfill the oil. Too much oil is almost as bad as too little oil. After refilling, start the engine and allow it to idle for about a minute. Stop the engine, wait about 5 minutes and check the oil level again.

Changing Engine Oil and Filter

Drain the engine oil while the engine is still warm.Suzuki New CARRY 2019 Drive Belt User Manual 06

  1. Remove the oil filler cap (1).Suzuki New CARRY 2019 Drive Belt User Manual 07
  2. Place a drain pan under the drain plug (2).
  3. Using a wrench, remove the drain plug and drain the engine oil.
    CAUTION
    The engine oil temperature may be high enough to burn your fingers when the drain plug is loosened. Wait until the drain plug is cool enough to touch with your bare hands.
  4. ket. Tighten the plug using a wrench to the specified torque. Tightening torque for drain plug 35 Nm (3.6 kg-m, 25.8 lbft).

WARNING
Engine oil can be hazardous. Children and pets may be harmed by swallowing new or used oil. Keep new and used oil and used oil filters away from children and pets. Repeated, prolonged contact with used engine oil may cause skin cancer. Brief contact with used oil may irritate skin. To minimize your exposure to used oil, wear a long-sleeve shirt and moisture-proof gloves (such as dish-washing gloves) when changing oil. If oil contacts your skin, wash thoroughly with soap and water. Launder any clothing or rags if it is with oil.
Recycle or properly dispose of used oil and filters.

Oil Filter ReplacementSuzuki New CARRY 2019 Drive Belt User Manual 08

  1. Remove the screws (1) from the engine under cover (3)
  2. Remove the clips (2) from the engine under cover (3).
    For removing the clips, use a flat-bladed screwdriver as shown in the illustration.
  3. Remove the engine undercover (3).
  4. Using an oil filter wrench, turn the oil filter counterclockwise and remove it.
  5. Using a clean rag, wipe off the mounting surface on the engine where the new filter will be seated.
  6. Smear a small amount of engine oil around the rubber gasket of the new oil filter.
  7. Screw the new filter by hand until the filter gasket contacts the mounting surface.

Suzuki New CARRY 2019 Drive Belt User Manual 09

  • Loosen
  • Tighten

Tightening (viewed from filter top)Suzuki New CARRY 2019 Drive Belt User Manual 10

  •  Oil filter
  • (7) 3/4 turn

NOTICE
To tighten the oil filter properly, it is important to accurately identify the position at which the filter gasket first contacts the mounting surface.
Tighten the filter as specified below from the point of contact with the mounting surface (or to the specified torque) using an oil filter wrench.

  • Tightening torque for oil filter
    3/4 turn or
    14 Nm (1.4 kg-m, 10.3 lb-ft)
  • NOTICE
  • To prevent oil leakage, make sure that the oil filter is tight, but do not over-tighten it.
  • Suzuki New CARRY 2019 Drive Belt User Manual 11
    Install the engine undercover (3)
  • Install the clips (2) and then push the center of the clips until the clips click.
  • Tighten the screws (1).

Refill with Oil and Oil Leakage Check

  1. Pour oil through the filler hole and install the filler cap. For the approximate capacity of the oil, refer to “Capacities” in the “SPECIFICATIONS” section.
  2. Start the engine and carefully check the oil filter and the drain plug for leakage. Run the engine at various speeds for at least 5 minutes.
  3. Stop the engine and wait about 5 minutes. Check the oil level again and add oil if necessary. Check for leakage again.

NOTICE
When replacing the oil filter, it is recommended that you use a genuine SUZUKI replacement filter. If you use an aftermarket filter, make sure it is of equivalent quality and follow the manufacturer’s instructions. Oil leakage from the periphery of the oil filter or drain plug indicates incorrect installation or gasket damage. If you find any leakage or are not sure that the filter has been properly tightened, have the vehicle inspected by a SUZUKI dealer or a qualified workshop.

Reference Links

View Full User Guide: Suzuki New CARRY 2019 User Manual

Download Manuals: https://suzuki-aftersales.net/manuals

Leave a Reply

Your email address will not be published. Required fields are marked *