Suzuki New ERTIGA 2020 Keyless Entry System Transmitter User Manual

Suzuki Logo

Suzuki New ERTIGA 2020 Keyless Entry System Transmitter User Manual

Keyless Entry System Transmitter

Suzuki New ERTIGA 2020 Keyless Entry System Transmitter User Manual 01

Your vehicle is equipped with either a keyless entry system transmitter (Type A) or a keyless push start system remote controller (Type B). The transmitter has only a keyless entry function. The remote controller has a keyless entry function and a keyless push-start system. The transmitter has only a keyless entry function. For details, refer to the following explanations.

WARNING
Radio waves from the keyless push start system antenna(s) may interfere with the operation of electrical medical equipment such as pacemakers. Failure to take the precautions listed below can increase the risk of severe injury or death due to radio wave interference.

  • Anyone who uses electrical medical equipment such as a pacemaker should consult the medical equipment supplier or their medical advisor about whether radio waves from the antenna(s) can interfere with the medical equipment. If radio wave interference is a concern, have the function of the antenna(s) disabled by a SUZUKI dealer or a qualified workshop.
  • Keyless Entry System Transmitter (Type A)Suzuki New ERTIGA 2020 Keyless Entry System Transmitter User Manual 02
  1. LOCK button
  2. UNLOCK button

You can lock or unlock all doors (including the tailgate) simultaneously by operating the transmitter near the vehicle.

Central door locking system

  1. To lock all doors, push the LOCK button (1) once.
  2. To unlock only the driver’s door, push UNLOCK button (2) once.
  3. To unlock other doors, push UNLOCK button (2) once again.

NOTE:
You can switch the function that unlocks all doors from requiring two pushes to requiring one push, and vice versa, via the information display setting mode. For details on how to use the information display, refer to “Information display” in this section. The turn signal lights will flash once when the doors are locked.

When the doors are unlocked:

  • The turn signal lights will flash twice.
    If the interior light switch is in the “DOOR” position, the interior light will turn on for about 15 seconds and then fade out. If you insert the key into the ignition switch during this time, the light will start to fade out immediately. Be sure the doors are locked after you operate the LOCK button (1).

NOTE:
If no door is opened within about 30 seconds after the UNLOCK button (2) is operated, the doors will automatically lock again.

NOTE:
The maximum operating distance of the keyless entry system transmitter is about 5 m (16 ft.), but this can vary depending on the surroundings, especially near other transmitting devices such as radio towers or CB (Citizen’s Band) radios. The door locks cannot be operated with the transmitter if the ignition key is inserted in the ignition switch.

  • When any door is open, the door locks can be operated only unlock with the transmitter.
    If you lose one of the transmitters, ask a SUZUKI dealer or a qualified workshop dealer as soon as possible for a replacement. Be sure to have your dealer program the new transmitter code in your vehicle’s memory so that the old code is erased.

NOTICE
The transmitter is a sensitive electronic instrument.

To avoid damaging the transmitter:
Do not expose it to impacts, moisture or high temperature such as by leaving it on the dashboard under direct sunlight.
Keep the transmitter away from magnetic objects such as a television.

Battery replacement

If the transmitter becomes unreliable, replace the battery.

To replace the battery of the transmitter:Suzuki New ERTIGA 2020 Keyless Entry System Transmitter User Manual 03

  1. Remove the screw (1), and open the transmitter cover.
    Remove the transmitter (2).
  2. Button type lithium battery: CR1616 or equivalent
    Suzuki New ERTIGA 2020 Keyless Entry System Transmitter User Manual 4
  3. Put the edge of a flat blade screwdriver covered with a soft cloth in the slot of the transmitter (2) and pry it open.
  4. Replace the battery (3) so its + terminal faces the “+” mark of the transmitter.
  5. Close the transmitter and install it into the transmitter holder.
  6. Close the transmitter cover, install and tighten the screw (1).
  7. Make sure the door locks can be operated with the transmitter.
  8. Dispose of the used battery properly according to applicable rules or regulations. Do not dispose of lithium batteries as ordinary household trash.

WARNING
Swallowing a lithium battery may cause serious internal injury. Do not allow anyone to swallow a lithium battery. Keep lithium batteries away from children and pets. If swallowed, contact a physician immediately.

NOTICE
The transmitter is a sensitive electronic instrument. To avoid damaging it, do not expose it to dust or moisture or tamper with internal parts.
When replacing the battery by yourself, the transmitter controller could be damaged or affected by static electricity. Discharge the static electricity built up in your body by touching metal before replacing the battery.

NOTE:
Used batteries must be disposed of properly according to applicable rules or regulations and must not be disposed of with ordinary household trash.Suzuki New ERTIGA 2020 Keyless Entry System Transmitter User Manual 5

(1) Crossed-out wheeled bin symbol
The crossed-out wheeled bin symbol (1) indicates that a used battery should be collected separately from ordinary household trash.
By ensuring the used battery is disposed of or recycled correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate battery disposal. The recycling of materials will help to conserve natural resources. For more detailed information about disposing of or recycling the used battery, consult a SUZUKI dealer or a qualified workshop.

Reference Links

View Full User Guide: Suzuki New ERTIGA 2020 User Manual

Download Manuals: https://suzuki-aftersales.net/manuals

Leave a Reply

Your email address will not be published. Required fields are marked *