Suzuki New ERTIGA 2020 Seat Belt Inspection User Manual

Suzuki Logo

Suzuki New ERTIGA 2020 Seat Belt Inspection User Manual

Seat Belt Inspection

Suzuki New ERTIGA 2020 Seat Belt Inspection User Manual 01

WARNING
Inspect all seat belt assemblies after any collision. Any seat belt assembly which was in use during a collision (other than a very minor one) should be replaced, even if damage to the assembly is not obvious. Any seat belt assembly which was not in use during a collision must be replaced if the airbags and the seat belt pre-tensioners are activated. The airbags, the pretensions, and the load limiter will only function once. In case they did not activate, consult with a SUZUKI dealer or a qualified workshop.

Child Restraint SystemsSuzuki New ERTIGA 2020 Seat Belt Inspection User Manual 02

The following types of child restraint systems are available generally.

Infant restraint – rear seat onlySuzuki New ERTIGA 2020 Seat Belt Inspection User Manual 03

Child restraintSuzuki New ERTIGA 2020 Seat Belt Inspection User Manual 04

Booster seatSuzuki New ERTIGA 2020 Seat Belt Inspection User Manual 05

SUZUKI highly recommends that you use a child restraint system to restrain infants and small children. Many different types of child restraint systems are available; check that the restraint system you select meets applicable safety standards. All child restraint systems are designed to be secured in vehicle seats either by seat belts (lap belts or the lap portion of lap-shoulder belts) or by special rigid lower anchor bars built into the seat. Whenever possible, SUZUKI recommends that child restraint systems be installed on the 2nd-row seat. According to accident statistics, children are safer when properly restrained in rear seating positions than in front seating positions. If you must use a front-facing child restraint in the front passenger’s seat, adjust the passenger’s seat as far back as possible.

NOTE:
Observe any statutory regulations about child restraints.Suzuki New ERTIGA 2020 Seat Belt Inspection User Manual 06

You may find this label on the sun visor.

WARNING
Do not install a rear-facing child restraint in the front passenger’s seat. If the passenger’s front airbag inflates, a child in a rear-facing child restraint could be killed or severely
injured. The back of a rear-facing child restraint would be too close to the inflating airbag.

WARNING
If you install a child restraint system in the 2nd-row seat, slide the seat and installed the child restraint system as far back as possible. So that the child’s feet do not contact the front
seatback. These will help avoid injury to the child in the event of an accident.Suzuki New ERTIGA 2020 Seat Belt Inspection User Manual 07Suzuki New ERTIGA 2020 Seat Belt Inspection User Manual 08

WARNING
Children could be endangered in a collision if their child restraint systems are not properly secured in the vehicle. When installing a child restraint system, follow the instructions
below. secure the child in the restraint system according to the manufacturer’s instructions.

Child Restraint System

CAUTION
Adjust the height of the head restraint or remove it for fitting the child restraint, as necessary. However, if a booster cushion not equipped with the head restraint is fitted, the seat head restraint should not be removed. If the head restraint is removed for fitting the child restraint, you need to install it again after removing the child restraint. If the child restraint is fitted improperly, a child sitting in it could be injured in a collision. (Refer to the “Installation with lap-shoulder seat belts” section, “Installation with ISOFIX type anchorages” section, and “Installation of child restraint with top tether” section in this section for details.).

Child Restraint (for the 2nd Row Center Seat Type with the Lap Belt)

The suitability of each passenger’s seat position for the carriage of children and the fitting of the child restraint system is shown in the table below. Child restraint systems suitability for each seat position.Suzuki New ERTIGA 2020 Seat Belt Inspection User Manual 09

NOTE:
The above illustration shows Right handle drive vehicle. Seat position number of, and is same as Right handle drive vehicle for Left handle drive vehicle.

  1. Front passenger’s seat
  2. 2nd seat right side
  3. 2nd seat left side
  4. 3rd seat right side
  5. 3rd seat left side
Seat position No.  

Marking

 

NOTICE

   

Suzuki New ERTIGA 2020 Seat Belt Inspection User Manual 10

1), 2), 3)
, Suzuki New ERTIGA 2020 Seat Belt Inspection User Manual 11 2), 3)
  Suzuki New ERTIGA 2020 Seat Belt Inspection User Manual 12
, Suzuki New ERTIGA 2020 Seat Belt Inspection User Manual 12
Marking Description
Suzuki New ERTIGA 2020 Seat Belt Inspection User Manual 13 It is suitable for the universal category of child restraint systems fixed with the vehicle seat belt.
Suzuki New ERTIGA 2020 Seat Belt Inspection User Manual 14 It is suitable for the ISOFIX child restraint system.
Suzuki New ERTIGA 2020 Seat Belt Inspection User Manual 15 This seat is equipped with a Top tether anchorage point.
Suzuki New ERTIGA 2020 Seat Belt Inspection User Manual 16 Never use a rear-facing child restraint system on the passenger seat.
Suzuki New ERTIGA 2020 Seat Belt Inspection User Manual 17 It is not suitable for a child restraint system.

NOTICE

  1. Move the front seat fully rearward.
  2. When you install a front-facing child restraint, if there is a gap or space between the child restraint and the seatback, adjust the seatback angle in order to install the child restraint system properly.
  3. If the head restraint interferes with the child restraint system, adjust the height of the head restraint or remove it, as necessary.
 

Seat position number

Seating position
           
Seating position suitable for universal belted (YES/NO) YES1) YES NO YES NO NO
i-Size seating position (YES/NO) NO NO NO NO NO NO
Seating position suitable for lateral fixture (L1/L2) NO X NO X NO NO
Suitable rear-facing fixture (R1/R2/R3) NO R1,R2,R3 NO R1,R2,R3 NO NO
Suitable front-facing fixture (F2X/F2/F3) NO F2X,F2,F3 NO F2X,F2,F3 NO NO

NOTE:
When installing the child restraint systems, only a front-facing child restraint is suitable.

Key of letters to be inserted in the above table

  1. YES =Suitable for this seating position
  2. NO = Not suitable for this seating position
  3. X =ISOFIX position is not suitable for ISOFIX child restraint systems in this fixture.

Reference Links

View Full User Guide: Suzuki New ERTIGA 2020 User Manual

Download Manuals: https://suzuki-aftersales.net/manuals

Leave a Reply

Your email address will not be published. Required fields are marked *