Tata Punch User 2021 Electronic Steering Column Lock Manual

Electronic Steering Column Lock (ESCL) Chime

This feature informs the driver to rotate the steering wheel when ESCL gets engaged accidentally.

WIF (Water in fuel)/FFC(fuel Filter Clog ) Chime

If water is detected in fuel buzzer shall sound to alert you.

Amt Fault Reminder

If Fault occur in AMT, 3-second audio warning will alert you.

COMBI-SWITCH (RH Stalk) (if available)

Left Turn Signal
Move the lever fully upward.
Right Turn Signal
Move the lever fully downward.
NOTE
When the turn is completed, the signal will cancel and the lever will return to its normal position.
High Beam
Move the lever forward to select the high beam function.
Pull the lever back to normal for low beam.
High Beam Flash (spring Return)
To flash the high beam, pull the lever to-wards you from the normal position. It will return to its normal position when you re-lease it.
Headlamp Rotary Switch
OFF Position
All lamps will remain ‘OFF’ Parking Lamp
Rotate stalk to turn ‘ON’ the Parking lamps.Low Beam
Rotate stalk to turn ‘ON’ the Low Beam function.Auto Light
The headlights will be automatically switched ON depending on ambient light conditions (while entering a tunnel or when it is twilight).
Day Time Running Lamps (DRL
Day time Running Lamps (DRL) are used to increase the visibility of the vehicle to other drivers during daytime.
1. To activate and deactivate DRL, keep the ignition switch is ‘ON’ position and switch the parking lamp ON-OFF twice.
2. Activation and Deactivation of DRL can be done by DRL soft switch, which is available on the Infotainment Display.
Lane Change Signal
To signal a lane change, move the lever slightly up or down to the point where the turn signal light begins to flash for six times, but the lever does not latch. The turn signal will flash six times automatically.

HEADLAMP LEVELING ROTARY SWITCH

Inner rotary switch on right hand stalk is provided for head lamp leveling. With the inner rotary switch, Head lamp leveling can be done with head lamp in Low Beam and in ‘ON’ position. Select correct position before start of trip, when the vehicle is stationary. Depending on the number of passengers and luggage in the vehicle headlamp focus may change. This can be adjusted by rotating the knob to one of the three level positions.

COMBI-SWITCH (LH Stalk) (if available)

0 ‘off’ Position
The wiper is switched ‘OFF’.

Intermittent Wipe
Push the stalk upwards to operate intermittent wipe.Inner rotary switch on left hand stalk is provided for intermittent front wiper delay. The switch has five delay timers. Push the stalk towards position (1) for single wipe.
Slow Wipe
Push the stalk towards position (2) for continuous slow wipe.
Fast Wipe
Push the stalk towards position (3) for con-tinuous fast wipe.
Flick Wipe (spring return)
Pull the stalk downwards and hold it for continuous wipe, the wiper continuously wipes across the wind-shield at low speed till the stalk is released.
Front Windshield Washer
- Pull the lever little longer, to spray the washer fluid on the windshield.
- The windshield wipers will operate for three cycles after the lever is released and for one more cycle after five seconds.
  NOTE
  When you crank the engine, the supply to washer motor is momentarily cut off.
  Auto Front Wipe
  If your vehicle is fitted with rain and light sensor, the wipers will automatically wipe the windscreen, if it senses rainfall. Make sure that the wiper stalk is in Auto position.
  NOTE
  When you crank the engine, the supply to washer motor is momentarily cut off.
Rear Wash And Wipe