Winnebago Sunstar 2023 FURNITURE AND SOFTGOODS User Manual

FURNITURE AND SOFTGOODS

SLEEPING FACILITIES

WARNING
Sleeping facilities are not intended for use while vehicle is in motion. For safety, passengers must use safety belted seating positions while vehicle is in motion.

DINETTE/BED CONVERSION –If Equipped

(Typical View – Your motorhome may differ in appearance)

Dinette to Bed

1. Under the table, turn the table retention bar over to unlock the table.
   
2. The table can then be pushed down all the way. The seats can be lifted slightly or removed to make the table pass down between the seats easier.
   
3. Place the 2 seat backs in the center forming the bed. Reverse the steps to return to the dinette configuration.
   
4. On the sides of the dinette table are buttons to open up the table to reveal storage space within the table.
   
5.  The picture below shows a close up on the button to press up that releases the lock. Both sides are pressed at the same time.
6. The table will pull upward at an angle, revealing the storage space inside. Reverse the steps to put the table away, making sure that both buttons snap back into place.
   

POWER LOFT BED –If Equipped

(Typical Views – Your motorhome may differ in appearance)
NOTE: The Power Loft Bed is not intended for storage. The Loft Bed is stowed near the cab ceiling as shown in the following photo.

To lower the Loft Bed for use

1. Locate the controls in the monitor panel Select the slide-out section and you will see the Bed Lift controls at the bottom. Select this and the lower and lift controls will be shown. Holding down the Lower button will lower the bed.

WARNING
Keep people away from operating mechanisms and pinch hazard areas during use. Failure to do so could cause injury.

To install the Mesh Netting

• Your Power Loft Bed is equipped with mesh netting (located in the wardrobe) that may be installed to the front side of the bed and front cabinet face.
• Insert the end of the mesh netting into the channel of the bed at either end and pull until the straps align with the brackets located on the cabinet face.

• Attach straps to the brackets located on the cabinet face.
• The bed is now ready for use. To access the Loft Bed see “Loft Bed Ladder” later in this section.
• Maximum Capacity: 600 lbs.
• To avoid injury to young children, do not leave them unattended on the bunk.

To store the Loft Bed

1. Locate the controls in the monitor panel. Select the slide-out section and you will see the Bed Lift controls at the bottom. Select this and the lower and lift controls will be shown. Holding down the Lift button will raise the bed.

Manual Retraction of Loft Bed

If the Power Loft Bed is malfunctioning you may need to manually retract the loft bed.

1. Pop out the bed motor panel located above the driver on the left side. Press in on the inside and the panel will pop out.
   

Your Power Loft Bed is equipped with mesh netting (located in the wardrobe) that may be installed to the front side of the bed and front cabinet face. Insert the end of the mesh netting into the channel of the bed at either end and pull until the straps align with the brackets located on the cabinet face.

• Maximum Capacity
• To avoid injury to young children, do not leave them unattended on the bunk.
• The table will pull upward at an angle, revealing the storage space inside. Reverse the steps to put the table away, making sure that both buttons snap back into place.

Reference Links

View Full User Guide: Winnebago Sunstar 2023 User Manual

Download link: https://www.winnebago.com/owners/owner-resources/manuals-and-diagrams/operator-manuals