2024 Nissan Sentra User Manual

2024 Nissan Sentra User Manual

The 2024 Nissan Sentra, a small sedan renowned for its value and usefulness, is the most recent addition to the legendary history of this car. The Sentra is a stylish and reasonably priced vehicle with a modern, streamlined design. Sharp LED headlights, a sleek, aerodynamic design, and Nissan’s recognizable V-motion grille are all on display from the outside. The interior of the cabin is roomy and cozy and is furnished with premium materials, giving it a premium appearance without the premium cost. Anticipated safety features and cutting-edge technology will set the 2024 Sentra apart in its class and make it a competitive option. The 2024 Nissan Sentra has a reputation for efficiency and dependability, which will make it appealing to consumers on a tight budget as well as those looking for a trustworthy daily car.

Malfunction

This warning appears when the Automatic Emergency Braking with Pedestrian Detection system or Intelligent Forward Collision Warning (I-FCW) system is not functioning properly. If one or more of these warnings appear, have the system checked. It is recommended that you visit a NISSAN dealer for this service.

Malfunction: See Owner’s Manual
This warning appears when one or more of the following systems are not functioning properly:

• Blind Spot Warning (BSW)
• Rear Cross Traffic Alert (RCTA)

If one or more of these warnings appear, have the system checked. It is recommended that you visit a NISSAN dealer for this service.

Not Available Poor Road Conditions
This message may appear when the Intelligent Cruise Control (ICC) system is engaged.

Under the following conditions, the ICC system is automatically cancelled:

• When the VDC operates
• When a wheel slips

The above system cannot be used in some situations (VDC operates and wheel slip).

Not Available System Malfunction
This warning appears when one or more of the following systems (if so equipped) is not functioning properly.

• Intelligent Cruise Control (ICC)
• Blind Spot Warning (BSW)
• Lane Departure Warning (LDW)
• Rear Automatic Braking (RAB)

If one or more of these warnings appear, have the system checked. It is recommended that you visit a NISSAN dealer for this service.

Parking Sensor Error: See Owner’s Manual
This warning appears when there is an error with the system.

Rear Automatic Braking (RAB) system warning indicator
This indicator appears to indicate the status of the Rear Automatic Braking (RAB) system.

Speed Limit Sign indicator
This message may appear when the Traffic Sign Recognition system is engaged.

Unavailable: High Cabin Temperature
This message appears when the camera detects an interior temperature of more than approximately 104°F (40°C).

Unavailable: High Camera Temperature
This message appears when the camera detects an interior temperature of more than 104°F (40°C).

Unavailable: Side Radar Obstruction
This message appears when the Blind Spot Warning (BSW)/Rear Cross Traffic Alert (RCTA) systems become unavailable because a radar blockage is detected.

The vehicle ahead detection indicator
This indicator appears when the following systems are engaged and have detected a vehicle:

• Automatic Emergency Braking (AEB) with Pedestrian Detection
• Intelligent Forward Collision Warning (I-FCW)

Your vehicle may have two types of security systems:

• Vehicle security system (if so equipped)
• NISSAN Vehicle Immobilizer System

VEHICLE SECURITY SYSTEM (if so equipped)
The vehicle security system provides visual and audible alarm signals if someone opens the doors when the system is armed. It is not, however, a motion detection type system that activates when a vehicle is moved or when a vibration occurs. The system helps detect vehicle theft but cannot prevent it, nor can it prevent the theft of interior or exterior vehicle components in all situations. Always secure your vehicle even if parking for a brief period. Never leave your keys in the vehicle, and always lock the vehicle when unattended. Be aware of your surroundings, and park in secure, well-lit areas whenever possible.
Many devices offering additional protection, such as component locks, identification markers, and tracking systems, are available at auto supply stores and speciality shops. A NISSAN dealer may also offer such equipment. Check with your insurance company to see if you may be eligible for discounts for various theft protection features.

How to arm the vehicle security system

1. Close all windows and the moonroof (if so equipped). The system can be armed even if the windows and moonroof are open.
2. Remove the Intelligent Key from the vehicle.
3. Close all doors, hood and trunk. Lock all doors. The doors can be locked with the Intelligent Key, door handle request switch (if so equipped) or power door lock switch.
4. Wait 30 seconds for the system to complete the pre-armed phase.
   If during the pre-armed phase, one of the following occurs, the system will not arm:
   • 4Any door is unlocked with the Intelli-gent Key or door request switch (if so equipped).
   • The ignition switch is placed in the AUTO ACC or ON position.

Even when the driver and/or passengers are in the vehicle, the system will activate when all the doors, hood and trunk are locked with the ignition switch placed in the LOCK position. When placing the ignition switch in the ON position, the system will be released.

Vehicle security system activation
The vehicle security system will give the following alarm:

• The headlights blink and the horn sounds intermittently.
• The alarm automatically turns off after a period of time. However, the alarm reactivates if the vehicle is tampered with again. The alarm can be shut off by pressing the button on the

Intelligent Key. The alarm is activated by:

• opening the door or trunk lid without using the key or Intelligent Key (even if the door is unlocked by releasing the door inside lock switch).

How to stop an activated alarm
The alarm stops only by unlocking a door, pressing the button on the Intelligent Key, or pushing the request switch (if so equipped) on the driver’s or passenger’s door with the Intelligent Key in range of the door handle.

NISSAN VEHICLE IMMOBILIZER SYSTEM
The NISSAN Vehicle Immobilizer System will not allow the engine to start without the use of a registered key. If the engine fails to start using a registered key (for example, when interference is caused by another registered key, an auto-mated toll road device or an automatic payment device on the key ring), restart the engine using the following procedures:

1. Leave the ignition switch in the ON position for approximately 5 seconds.
2. Place the ignition switch in the OFF or LOCK position and wait approximately 10 seconds.
3. Repeat steps 1 and 2.
4. Restart the engine while holding the de-vice (which may have caused the interference) separate from the registered key.

If the no-start condition re-occurs, NISSAN recommends placing the registered key on a separate key ring to avoid interference from other devices.

Never leave these keys in the vehicle.

FCC Notice:

For the USA:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

NOTE:
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

For Canada:
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions: (1) This device may not cause interference. (2) This device must accept any interference, including interference that may cause undesired operation of the device.

WIPER AND WASHER SWITCH

SWITCH OPERATION

WARNING
In freezing temperatures, the washer solution may freeze on the windshield and obscure your vision which may lead to an accident. Warm the windshield with the defroster before you wash the windshield.

CAUTION

• Do not operate the washer continuously for more than 30 seconds.
• Do not operate the washer if the windshield washer fluid reservoir is empty.
• Do not fill the windshield-washer fluid reservoir with windshield-washer fluid concentrates at full strength. Some methyl alcohol-based windshield-washer fluid concentrates may permanently stain the grille if spilt while filling the windshield-washer fluid reservoir.
• Pre-mix windshield-washer fluid concentrates with water to the manufacturer’s recommended levels before pouring the fluid into the windshield-washer fluid reservoir. Do not use the windshield washer fluid reservoir to mix the windshield washer fluid concentrate and water.

NOTE:
If the windshield wiper operation is interrupted by snow or ice, the wiper may stop moving to protect its motor. If this occurs, turn the wiper switch to the OFF position and remove the snow or ice that is on and around the wiper arms. In approximately 1 minute, turn the switch on again to operate the wiper.

The windshield wiper and washer operate when the ignition switch is placed in the ON position.

Push the lever down to operate the wiper at the following speed:

1. Intermittent — intermittent operation can be adjusted by turning the knob toward OA (faster) or OB (slower). Also, the intermittent operation speed varies in accordance with the vehicle speed.(For example, when the vehicle speed is high, the intermittent speed will be faster.)
2. Low — continuous low-speed operation
3. High — continuous high-speed operation

Push the lever up 4O to have one sweep operation (MIST) of the wiper. Pull the lever toward your 5O to operate the washer. The wiper will also operate several times.

NOTE:
The Wiper with Speed feature may be disabled.

REAR WINDOW AND OUTSIDE MIRROR (if so equipped) DEFROSTER SWITCHTo defrost the rear window glass and outside mirrors (if so equipped), start the engine and push the rear window defroster switch on. The rear window defrosters the indi-cator light on the switch comes on. Push the switch again to turn the defroster off. The rear window defroster automatically turns off after approximately 15 minutes.

CAUTION

• Use the defroster when the engine is running to avoid discharging the battery.
• When cleaning the inner side of the rear window, be careful not to scratch or damage the rear window defroster.

High Beam Assist (if so equipped)
The High Beam Assist system will operate when the vehicle is driven at speeds of approximately 25 mph (40 km/h) and above. If an oncoming vehicle or leading vehicle appears in front of your vehicle when the headlight’s high beam is on, the headlight will be switched to the low beam automatically.

WARNING

• The High Beam Assist system is a convenience but it is not a substitute for safe driving operation. The driver should remain alert at all times, ensure safe driving practices and switch the high beams and low beams manually when necessary.
• The high beam or low beam may not switch automatically under the following conditions. Switch the high beam and low beam manually.
  • During bad weather (rain, fog, snow, wind, etc.).
  • When a light source similar to a headlight or tail light is in the vicinity of the vehicle.
  • When the headlights of the coming vehicle or the leading vehicle are turned off, when the colour of the light is affected due to foreign materials on the lights, or when the light beam is out of position.
  • When there is a sudden, continuous change in brightness.
  • When driving on a road that passes over rolling hills, or a road that has level differences.
  • When driving on a road with many curves.
  • When a sign or mirror-like surface is reflecting intense light towards the front of the vehicle.
  • When the container, etc. being towed by a leading vehicle is reflecting intense light.
  • When a headlight on your vehicle is damaged or dirty.
  • When the vehicle is leaning at an angle due to a punctured tire, being towed, etc.
• The timing of switching the low beam and high beam may change under the following situations.
  • The brightness of the headlights of the oncoming vehicle or leading vehicle.
  • The movement and direction of the oncoming vehicle and the leading vehicle.
  • When only one light on the on-coming vehicle or the leading vehicle is illuminated.
  • When the oncoming vehicle or the leading vehicle is a two-wheeled vehicle.
  • Road conditions (incline, curve, the road surface, etc.).
  • The number of passengers and the amount of luggage.

FAQs

Useful Link

DownloadManuals:https://www.nissanusa.com/owners/ownership/manuals-guides.html

Nissan ROGUE 2022 User Guide

2023 Nissan Sentra Specs, Price, Features and Mileage (Brochure)