2021 Aston Martin Valkyrie Engine Oil and Fluids Guide
The 2021 Aston Martin Valkyrie is a hypercar that pushes the limits of performance and innovation. It is a true work of automotive engineering. A carefully tuned engine powers this remarkable vehicle, and choosing the right engine oil and fluids is crucial to keeping that engine running at its best. We will dig into the realm of engine oil and fluids for the Aston Martin Valkyrie in this introduction, learning about the specific mixtures that guarantee the supercar’s engine beats with accuracy, power, and lifespan. These elements, which range from specialized lubricants to cutting-edge cooling fluids, are crucial in raising the Valkyrie’s performance to astounding levels. Let’s learn more about the fluids used to create the 2021 Aston Martin Valkyrie.
To avoid overheating during strenuous driving hours, the Aston Martin Valkyrie also features cutting-edge cooling fluids. These fluids are designed to withstand the extreme heat produced by the brakes and engine, keeping the Valkyrie cool under duress on the racetrack and on the open road. The 2021 Aston Martin Valkyrie’s engine oil and fluids are no exception to the meticulous engineering that permeates the hypercar industry. These fluids are essential to the Valkyrie’s unmatched performance and are not simply functional; they also make sure that this amazing vehicle performs to the very best of its potential. The precise nuances of the engine oil and fluids that make the Aston Martin Valkyrie a genuinely unique vehicle will become clear as we go more into this subject.
Engine Cover Release
To open the engine cover, pull the lever located in the left side door aperture.
Slightly lift the rear edge of the engine cover to lift it. The engine cover is held open by a carbon rod.
Fluid Checks and Capacities
Front Fluid Reservoirs
- Windscreen washer fluid reservoir
- Brake reservoirs
Engine Bay Fluid Reservoirs
Warning
Engine components may be hot and could cause severe burns.
- Engine coolant reservoir.
- Engine oil filler cap and dip stick.
- Battery coolant reservoir.
- ERS coolant reservoir.
Engine Oil Level
Warning
Engine oil or components may be hot and could cause severe burns.
Caution
- Running the engine with engine oil below the lower mark or above the upper mark can cause serious engine damage.
- This vehicle’s warranty may be invalidated if damage is caused by the use of incorrect engine oil. Low quality or obsolete oils do NOT give the protection required by modern, high performance engines.
- Failure to use engine oil that meets the required specification can cause excessive engine wear, a build up of sludge and deposits, and increased pollution. It could also lead to engine failure.
- Care must be taken when oil is checked or added. If oil drips onto any of the engine hoses, this can cause them to swell and become damaged over time.
Engine Oil Level Check
- Make sure the vehicle is on level ground.
- Run the engine until the oil temperature is 75°C or higher. Engine oil temperature can be checked in the infotainment system (Refer to ’Vehicle Menu’).
- Once the oil temperature is at least 75°C, increase the engine speed to 3000 rpm and hold for 30 seconds.
- Turn the engine off.
For the oil level check process, the oil temperature must be between 75°C and 85°C - Between 10 and 20 seconds after the engine is turned off, unscrew the oil filler cap. Withdraw and wipe the dipstick with a clean lint free cloth.
- Fully insert the dipstick into the oil tank, and withdraw the dipstick again.
- The engine oil level should read between the Min. (A) and Max. (B) indentation marks.
- If more oil is required, top up with the recommended engine oil. Do not overfill. For the correct engine oil (Refer to ’Engine Oil’.
- If more oil is added, do steps 3 to 7 again until the oil level is correct.
- Insert the dipstick back into the oil tank and securely tighten the oil filler cap.
Coolant Levels
Warning
Do not remove a filler cap until the coolant system has cooled. Scalding can be caused by escaping steam or coolant.
Use a cloth or glove to protect hands and protect face and arms adequately.
- Remove the reservoir cap to check the coolant level.
- Make sure that the reservoir cap is secure after topping up.
Caution
Do not over tighten the reservoir cap. This can cause damage to the reservoir cap or the thread for the reservoir tank.
Coolant Identification
Engine Coolant/ERS Coolant
Battery Coolant
Warning
Do not mix battery coolant with ERS coolant or engine coolant. Incorrect coolant for the high voltage battery can cause irreparable damage that can cause serious injury.
Brake Fluid Level
Warning
Do not drive the vehicle if the brake fluid level is below the minimum mark in either reservoir.
Caution
Make sure that the brake fluid does not contact the paint work during the topping up operation. Serious paint work damage can result. If a spillage does occur, immediately flush any brake fluid from the paint work with clean, fresh water and then wipe with a clean damp cloth.
The brake fluid level should read between the Min. and Max. marks.
- Remove the reservoir cap. Top up to the Min. fill line.
- Install the reservoir cap securely.
Fluid Specifications
Fuel
Minimum 95 RON unleaded fuel.
Recommended 99 RON Super unleaded for optimum performance. Use of fuel with more than 10% ethanol is not permitted.
Engine Oil
Caution
To achieve the required high performance of synthetic lubricants, do not mix with mineral oils.
A fully synthetic 0W-40 oil meeting the specifications detailed below can be used. No other viscosity grades or specifications are acceptable.
Coolant
Engine Coolant
Glysantin BASF G40 (70% water to 30% BASF G40 mix)
ERS Coolant
Glysantin BASF G40 (70% water to 30% BASF G40 mix)
High Voltage Battery Coolant
Galden HT170
Brake Fluid
Castrol React SRF Racing Dot 4
Air Conditioning Refrigerant
HFO-1234yf
Air Conditioning Compressor Oil
Caution
Only a non-conductive Polyalkylene Glycol (PAG) oil can be used in the HV compressor. Standard PAG oils are conductive and will cause irreparable damage to the compressor.
Sanden SPA-2
Transmission Oil
Castrol Transmax Limited Slip LL 75W-140
Hydraulic Fluid
Pentosin CHF 202
Power Steering Fluid
Pentosin CHF 202
Fire Suppression System
Novec 1230
Capacities
- Fuel Tank 50 Litres
Engine Oil (including filter) 10.0 Litres - Engine Coolant 10.5 Litres
(Includes ERS coolant) - HV Battery Coolant 2.0 Litres
- Transmission Fluid 6.0 Litres
- Hydraulic System 4.9 Litres
- Power Steering Fluid 0.3 Litres
- Screen Washer Reservoir 1.6 Litres
- Brake Fluid 1.0 Litres
FAQs
A high-performance synthetic engine oil that has been specially designed is necessary for the 2021 Aston Martin Valkyrie. Utilizing the oil indicated in the owner’s manual is advised.
For typical driving conditions, Aston Martin advises replacing the engine oil every 12 months or 5,000 kilometers, whichever comes first.
It is advised to use the oil indicated in the owner’s manual or another oil that complies with the standards needed for high-performance engines.
When changing the oil and filter, the Aston Martin Valkyrie 2021 can hold about 8.5 liters (9 quarts) of oil.
For maximum transmission performance, the Aston Martin Valkyrie 2021 needs a certain brand of high-performance transmission oil, according to the manufacturer.
To guarantee smooth and effective gear shifting, it is advised to check the transmission fluid level every 10,000 miles or once a year, whichever comes first.
To ensure the transmission system performs optimally and lasts as long as possible, it is advised to use the transmission fluid recommended by Aston Martin.
For the best engine cooling, the Aston Martin Valkyrie 2021 needs a certain brand of long-life coolant that the manufacturer recommends.
To preserve the effectiveness of the cooling system, it is advised to flush and refill the coolant every two years or 30,000 miles, whichever comes first.
To avoid any potential chemical reactions that could harm the cooling system, it is advised to use only the recommended coolant type.
In order to get the best power steering performance, the Aston Martin Valkyrie 2021 uses a particular kind of power steering fluid.
To ensure the effective operation of the power steering system, it is advised to check the power steering fluid level during each regular maintenance check.
To maintain the greatest performance and longevity of the power steering system, it is advised to use the power steering fluid recommended by Aston Martin.
For the best braking performance, the Aston Martin Valkyrie 2021 utilizes a specific brand of high-performance brake fluid.
For the purpose of preserving the effectiveness of the brake system and preventing brake fade, it is advised to flush and change the brake fluid every two years or 20,000 miles, whichever comes first.
Useful Links
Download Manuals: 2021 Aston Martin Valkyrie User Manual
2021 Aston Martin Valkyrie Maintenance Schedule
