Kia Stinger 2022 Emission Control System
The emission control system in the 2022 Kia Stinger shows how committed Kia is to environmental duty and following the rules. It was carefully designed to reduce the amount of harmful pollutants that are released into the air. This complex system has many high-tech parts, such as catalytic converters, oxygen sensors, exhaust gas recirculation (EGR) systems, and evaporative emissions control (EVAP) systems. These all work together to make the car less harmful to the environment while also improving engine performance. The 2022 Kia Stinger also meets strict pollution standards set by regulatory bodies such as the California Air Resources Board (CARB). This makes sure that it not only has great power and style, but also runs in an eco-friendly way. As part of this promise, Kia gives out a California Perchlorate Notice, which shows that the brand is committed to being open and caring for the environment, especially in a place where strict environmental rules are very important.
2023 Kia Stinger Specs, Price, Features and Mileage (Brochure)
Emission control system
The emission control system of your vehicle is covered by a written limited warranty. Please see the warranty information contained in the Warranty & Consumer Information manual in your vehicle. Your vehicle is equipped with an emission control system to meet all applicable emission regulations.
There are three emission control systems, as follows.
- Crankcase emission control system
- Evaporative emission control system
- Exhaust emission control system In order to ensure the proper function of the emission control systems, it is recommended that you have your vehicle inspected and maintained by an authorized Kia dealer in accordance with the maintenance schedule in this manual.
Caution for the Inspection and Maintenance Test (With Electronic Stability Control (ESC) system)
- To prevent the vehicle from misfiring during dynamometer testing, turn the Electronic Stability Control (ESC) system off by pressing the ESC switch.
- After dynamometer testing is completed, turn the ESC system back on by pressing the ESC switch again.
Crankcase emission control system
The positive crankcase ventilation system is employed to prevent air pollution caused by blow-by gases being emitted from the crankcase. This system supplies fresh filtered air to the crankcase through the air intake hose. Inside the crankcase, the fresh air mixes with blow-by gases, which then pass through the PCV valve into the induction system.
Evaporative emission control (including ORVR: Onboard Refueling Vapor Recovery) system
The Evaporative Emission Control System is designed to prevent fuel vapors from escaping into the atmosphere.
(The ORVR system is designed to allow the vapours from the fuel tank to be loaded into a canister while refuelling at the gas station, preventing the escape of fuel vapours into the atmosphere.)
Canister
Fuel vapours generated inside the fuel tank are absorbed and stored in the onboard canister. When the engine is running, the fuel vapours absorbed in the canister are drawn into the surge tank through the purge control solenoid valve.
Purge Control Solenoid Valve (PCSV)
The purge control solenoid valve is controlled by the Engine Control Module (ECM); when the engine coolant temperature is low during idling, the PCSV closes so that evaporated fuel is not taken into the engine. After the engine warms up during ordinary driving, the PCSV opens to introduce evaporated fuel to the engine.
2023 Kia Stinger Specs, Price, Features and Mileage (Brochure)
Exhaust emission control system
The Exhaust Emission Control System is a highly effective system that controls exhaust emissions while maintaining good vehicle performance.
Engine exhaust gas precautions (carbon monoxide)
- Carbon monoxide can be present with other exhaust fumes. Therefore, if you smell exhaust fumes of any kind inside your vehicle, have it inspected and repaired immediately. If you ever suspect exhaust fumes are coming into your vehicle, drive it only with all the windows fully open. Have your vehicle checked and repaired immediately.
WARNING
Exhaust
Engine exhaust gases contain carbon monoxide (CO). Though colorless and odourless, it is dangerous and could be lethal if inhaled. Follow the instructions on this page to avoid CO poisoning.
- Do not operate the engine in confined or closed areas (such as garages) any more than what is necessary to move the vehicle in or out of the area.
- When the vehicle is stopped in an open area for more than a short time with the engine running, adjust the ventilation system (as needed) to draw outside air into the vehicle.
- Never sit in a parked or stopped vehicle for any extended time with the engine running.
- When the engine stalls or fails to start, excessive attempts to restart the engine may cause damage to the emission control system.
Operating precautions for catalytic converters (if equipped)
WARNING
Catalytic converter
Keep away from the catalytic converter and exhaust system while the vehicle is running or immediately thereafter. The exhaust and catalytic systems are very hot and may burn you.
WARNING
Fire
- Do not park, idle or drive the vehicle over or near flammable objects, such as grass, vegetation, paper, leaves, etc. A hot exhaust system can ignite flammable items under your vehicle.
- Also, do not remove the heat sink around the exhaust system, do not seal the bottom of the vehicle or do not coat the vehicle for corrosion control. It may present a fire risk under certain conditions.
Your vehicle is equipped with a catalytic converter emission control device.
Therefore, the following precautions must be observed:
- Use only UNLEADED FUEL for gasoline engines.
- Do not operate the vehicle when there are signs of engine malfunction, such as a misfire or a noticeable loss of performance.
- Do not misuse or abuse the engine. Examples of misuse are coasting with the ignition off and descending steep grades in gear with the ignition off.
- Do not operate the engine at high idle speed for extended periods (5 minutes or more).
- Do not modify or tamper with any part of the engine or emission control system. All inspections and adjustments must be made by an authorized Kia dealer.
- Avoid driving with an extremely low fuel level. Running out of fuel could cause the engine to misfire, damaging the catalytic converter.
Failure to observe these precautions could result in damage to the catalytic converter and to your vehicle. Additionally, such actions could void your warranties.
California perchlorate notice
Perchlorate Material-special handling may apply, See www.dtsc.ca.gov/hazardouswaste/ perchlorate.
Notice to California Vehicle Dismantlers:
Perchlorate-containing materials, such as air bag inflators, seatbelt pre-tensioners and keyless remote entry batteries, must be disposed of according to Title 22 California Code of Regulations Chapter 67384.10 (a).
FAQ
A: The emission control system is designed to reduce the release of harmful pollutants from the vehicle’s exhaust, ensuring compliance with environmental regulations and improving air quality.
A: Common components include the catalytic converter, oxygen sensors, exhaust gas recirculation (EGR) system, and evaporative emissions control system (EVAP).
A: The catalytic converter converts harmful gases like carbon monoxide (CO) and nitrogen oxides (NOx) into less harmful substances through chemical reactions.
A: Oxygen sensors monitor the oxygen content in the exhaust gases and provide feedback to the engine control unit (ECU) to optimize the air-fuel mixture for efficient combustion and reduced emissions.
A: The EGR system recirculates a portion of exhaust gases back into the engine’s intake to lower combustion temperatures and reduce nitrogen oxide (NOx) emissions.
A: The EVAP system captures and stores fuel vapors from the fuel tank, preventing them from escaping into the atmosphere and later allows the engine to burn these vapors.
A: Yes, the proper functioning of the emission control system is essential for a vehicle to pass emissions tests and meet regulatory requirements.
A: Yes, emission control system issues can lead to reduced engine performance, decreased fuel efficiency, and trigger warning lights on the dashboard.
A: Common signs of problems include the check engine light coming on, rough engine idling, decreased fuel efficiency, or unusual exhaust odors.
A: Some basic maintenance, such as inspecting for loose or damaged components, can be done by vehicle owners. However, complex issues may require professional diagnosis and repair.
A: Kia provides guidelines for regular inspection and maintenance of the emission control system, typically outlined in the owner’s manual.
A: It’s advisable to have the vehicle inspected by a qualified technician who can diagnose and address the issue promptly.
A: Catalytic converters are designed to last for many years. Replacement is typically necessary only if it fails or becomes clogged.
A: Emission control components are usually covered under Kia’s emissions warranty, which may extend beyond the standard vehicle warranty. Review the specific warranty terms for your Stinger.
A: To maintain the system’s efficiency, follow the recommended maintenance schedule, use high-quality fuel, and address any issues promptly to prevent emissions-related problems.
Useful Link
View Full PDF: Kia Stinger 2022 User Guide
Download Manuals: https://owners.kia.com/content/owners/en/manuals.ht
2023 Kia Stinger Specs, Price, Features and Mileage (Brochure)
