
Table of Contents
Toggle2025 Honda Civic Wipers and Washers User Guide
This tutorial covers the 2025 Honda Civic’s wipers and washers. Rain-sensing wipers, adjustable speed settings, and a high-efficiency washer system improve visibility and safety. Get into the details.
2024 Honda Civic Specs, Price, Features, Mileage (Brochure)
Wipers and Washers
Windshield Wiper/Washer
The windshield wipers and washers can be used when the power mode is in ON.

MIST
The wipers run at high speed until you release the lever.
Wiper switch (OFF, INT*1/AUTO*2, LO, HI)
Move the lever up or down to change the wiper settings.
Adjusting wiper operation
Turn the adjustment ring to adjust the wiper operation.
![]()
Higher speed, more sweeps
Washer
Sprays on the windshield and front-view camera* while you pull the lever toward you.
When you release the lever for more than one second, the spray stops, the wipers sweep two or three more times to clear the windshield, then stop.
- Models with manual intermittent operation
- Models with automatic intermittent operation
When lifting the wiper arms, move them into the maintenance position before lifting them.
NOTICE
Do not use the wipers when the windshield is dry.
The windshield will get scratched, or the rubber blades will get damaged.
Turn the washers off if no washer fluid comes out.
The pump may get damaged.
If the vehicle speeds up while the wipers are operating intermittently, the length of the wipeinterval shortens.
When the vehicle speeds up, the wiper operation’s shortest delay setting
and the LO setting become the same.
NOTICE
In cold weather, the blades may freeze to the windshield.
Operating the wipers in this condition may damage the wipers. Use the defogger or heated windshield* to warm the windshield, then turn the wipers on.
If the wipers stop operating due to an obstacle such as the buildup of snow, park the vehicle in a safe place.
Rotate the wiper switch to OFF, set the power mode to ACCESSORY or VEHICLE OFF, then remove the obstacle.
Automatic Intermittent Wipers
When you push the lever down to AUTO, the windshield wipers sweep once, and go into the automatic mode.

The wipers operate intermittently, at low speed, or at high speed and stop in accordance with the amount of rainfall the rainfall sensor detects.
Auto sensitivity adjustment
When the wiper function is set to AUTO, you can adjust the sensitivity of the rainfall sensor (using the adjustment ring) so that wipers will operate in accordance with your preference.
Sensor sensitivity
![]()
High sensitivity
The rainfall sensor is in the location shown below.

AUTO should always be turned OFF before the following situations in order to prevent severe damage to the wiper system:
- Cleaning the windshield
- Driving through a car wash
- No rain present