Kia Sportage 2022
Rear View Monitor (RVM) and Reverse Parking Distance Warning (PDW) User Guide
Rear View Monitor (RVM)
Rear View Monitor will activate with the ignition switch or ENGINE START/STOP button in the ON and the shift lever in the R (Reverse) position.
The rear view monitor may be turned off by pressing the ON/OFF button when the rear view monitor is activated.
To turn the camera on again, press the ON/OFF button again when the ignition switch is on and the shift lever is in R (Reverse). Also, the camera will turn on automatically whenever the ignition switch is turned off and on again.
- This system is a supplementary function only. It is the responsibility of the driver to always check the inside/outside rearview mirrors and the area behind the vehicle before and while backing up because there is a dead zone that can’t be seen by the camera.
- If the camera lens is covered with foreign material, the Rear View Monitor may not operate normally. Always keep the camera lens clean.
However, do not use chemical sol-vents such as strong detergents containing high alkaline or volatile organic solvents (gasoline, ace-tone etc.). This may damage the camera lens
If your vehicle is equipped with an Infotainment System, rearview dis-play will show through the Infotainment System, monitor while backing-up. Refer to a separately supplied manual for detailed information.
WARNING
Backing up & using camera
Never rely solely on the rear view camera when backing. You must always use methods of viewing the area behind you including looking over both shoulders as well as continuously checking all three rear view mirrors. Due to the difficulty of ensuring that the area behind you remains clear, always back slowly and stop immediately if you even suspect .
This system is a supplemental system that shows behind the vehicle through the rearview dis-play mirror while backing up. If the vehicle is equipped with a navigation system, then the system will display on the screen.
REVERSE PARKING DISTANCE WARNING (PDW) (IF EQUIPPED)
Reverse Parking Distance Warning assists the driver during backward movement of the vehicle by chiming if any object is sensed within a distance of 47 in. (120 cm) behind the vehicle.
This system is a supplemental system and it is not intended to nor does it replace the need for extreme care and attention of the driver. The sensing range and objects detectable by the back sensors (➀) are limited. Whenever backing-up, pay as much attention to what is behind you as you would in a vehicle without Reverse Parking Distance Warning.
WARNING
Reverse Parking Distance Warning
Never rely solely on Reverse Parking Distance Warning. Always perform a visual inspection to make sure the vehicle is clear of all obstructions before moving the vehicle in any direction. Stop immediately if you are aware of a child anywhere near your vehicle. Some objects may not be detected by the sensors, due to the object’s size or material.
Operation of Reverse Parking Distance Warning
Operating condition
- This system will activate when the indicator on the Reverse Parking Distance Warning system OFF but-ton is not illuminated. If you desire to deactivate Reverse Parking Distance Warning, press the Parking Safety button again. (The indicator on the button will illuminate.) To turn the system on, press the button again. (The indicator on the button will go off.)
- This system will activate when backing up with the ignition switch ON.
If the vehicle is moving at a speed over 3 mph (5 km/h), the system may not be activated correctly. - The sensing distance while the back-up warning system is in operation is approximately 47 in. (120
cm) at the rear bumper center area, 23.5 in. (60 cm) at the rear bumper both side area. - If vehicle speed exceeds 6 mph (10 km/h), the system will not warn you even though objects are detected.
- When more than two objects are sensed at the same time, the closest one will be recognized first.
| Types of warning sound | Indicator* |
| When an object is 24 in. to 48 in. (120 cm to 60 cm) from the rear bumper: Buzzer beeps intermittently. |  |
| When an object is 12 in. to 24 in. (60 cm to 30 cm) from the rear bumper:
Buzzer beeps more frequently. |
 |
| When an object is within 12 in. (30 cm) of the rear bumper: The buzzer sounds continuously. |
 |
Non-operational conditions of Reverse Parking Distance Warning
Reverse Parking Distance Warning may not operate properly when:
- Moisture is frozen to the sensor. (It will operate normally once the moisture clears.
- The sensor is covered with foreign matter, such as snow or water, or the sensor cover is blocked. (It will operate normally when the material is removed or the sensor is no longer blocked.)
- Driving on uneven road surfaces (unpaved roads, gravel, bumps, gradient).
- Objects generating excessive noise (vehicle horns, loud motor-cycle engines, or truck air brakes) are within range of the sensor.
- The weather conditions produce heavy rain or water spray.
- Wireless transmitters or mobile phones are within range of the sensor.
- The sensor is covered with snow.
- Trailer towing
The detecting range may decrease when:
- The sensor is covered with foreign matter such as snow or water.(The sensing range will return to normal when removed.)
- The outside air temperature is extremely hot or cold.
The following objects may not be recognized by the sensor:
- Sharp or slim objects such as ropes, chains or small poles.
- Objects that tend to absorb the sensor frequency such as clothes, sound absorbent material or snow.
- Undetectable objects smaller than 40 in. (100 cm) in height and narrower than 6 in. (14 cm) in diameter.
Reverse Parking Distance Warning Precautions
- Reverse Parking Distance Warning may not sound consistently depending on the speed and shapes of the objects detected.
- Reverse Parking Distance Warning may malfunction if the vehicle bumper height or sensor installation has been modified or damaged. Any non-factory installed equipment or accessories may also interfere with the sensor performance.
- The sensor may not recognize objects less than 12 in. (30 cm) from the sensor, or it may sense an incorrect distance. Use caution.
- When the sensor is frozen or covered with snow, dirt, or water, the sensor may be inoperative until the material is removed using a soft cloth.
- To prevent damage, do not push, scratch or strike the sensor.
NOTICE
This system can only sense objects within the range and location of the sensors. It cannot detect objects in other areas where sensors are not installed. Also, small or slim objects, such as poles or objects located between sensors may not be detected by the sensors.
Always visually check behind the vehicle when backing up.
Be sure to inform any drivers of the vehicle that may be unfamiliar with the system regarding the system’s capabilities and limitations.
Self-diagnosis
If you don’t hear an audible warning sound or if the buzzer sounds intermittently when shifting the gear to the R (Reverse) position, this may indicate a malfunction in the Reverse Parking Distance Warning. If this occurs, have your vehicle checked by an authorized Kia dealer as soon as possible.
NOTICE
Your new vehicle warranty does not cover any accidents or damage to the vehicle or injuries to its occupants due to Reverse Parking Distance Warning malfunction. Always drive safely and cautiously.
[amalinkspro_table id=”31533″ new-window=”on” nofollow=”on” addtocart=”on” /]
Reference Links
View Full User Guide: Kia Sportage 2022 User Guide
Download Manuals: https://owners.kia.com/content/owners/en/manuals.html
2023 KIA SPORTAGE Specs, Price, Features, Mileage (Brochure)
